Mazda 6 Service Manual: Clutch pedal removal/installation
1. Remove the battery and battery tray. (European (L.H.D.) and GCC specs.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. After installation, adjust the clutch pedal. (See CLUTCH PEDAL ADJUSTMENT.)
у
Clutch Pedal Installation Note
After installation, adjust the pedal height and free play. (See CLUTCH PEDAL ADJUSTMENT.)
Clutch pedal adjustment
Clutch Pedal Height
Measure the distance from the upper surface of the pedal pad to the carpet.
If not as specified, adjust the pedal height by turning adjustment bolt
B and locknut A.
P ...
Other materials:
Mazda 6 Service Manual: Rear washer hose removal/installation
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Partially peel off the right side mud guard.
4. Remove rear washer hose No.1 from the clips.
5. Remove rear washer hose No.1 and joint pipe A.
6. Remove the A-pillar trim. (See A-PIL ...
Mazda 6 Service Manual: Refrigerant pressure switch inspection
1. Install the SST (gas charging set).
2. Disconnect the refrigerant pressure switch connector.
3. Verify the high-pressure side reading of the SST (manifold gauge)
and continuity between the terminals of the refrigerant pressure switch.
If not as specified, replace the refrigerant pressure ...