1. Disconnect the negative battery cable.
2. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.


4. Install in the reverse order of removal.
5. After installation, verify that the rubber of the center roof antenna is installed to the roof panel with no space between them.
Condenser removal/installation
Center roof antenna inspectionMazda 6 Service Manual: No.4 air intake mode does not change
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while performing the inspection to discover
whether poor contact points are the cause of any intermittent malfunctions.
If there is a problem, check to make sure connectors, terminal ...
Mazda 6 Service Manual: Fuel Gauge (Without Multiinformation Display)
The fuel gauge shows approximately how much fuel is remaining in the tank when
the ignition is switched ON. We recommend keeping the tank over 1/4 full.
If the low fuel warning light illuminates or the fuel level is very low, refuel
as soon as possible.
Refer to Warning Lights.
NOTE
...