Mazda 6 Service Manual: Air intake actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the air intake actuator.
2. Verify that the air intake actuator operates as shown below.
- If not as specified, replace the air intake actuator.
Air intake actuator removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT
REMOVAL/INSTALLATION.)
4. Remove in the order indicated in t ...
Air mix actuator removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT
REMOVAL/INSTALLATION.)
4. Remove in the order indicated in t ...
Other materials:
Mazda 6 Service Manual: Power window motor removal/installation
1. Disconnect the negative battery cable.
2. Remove the front door trim or rear door trim.
3. Disconnect the power window motor connector.
4. Remove the bolts.
5. Remove the power window motor from the power window regulator drum.
6. Install in the reverse order of removal.
Note
When ins ...
Mazda 6 Service Manual: Fog Lights (Some models)
The fog lights can be turned on with the ignition switched ON and the headlights
turned on.
Use this switch to turn on the fog lights. The fog lights will improve visibility
at night and during foggy conditions.
The fog lights turn on when the fog light switch is turned to the
position and t ...