Mazda 6 Owners Manual: Advanced Keyless Entry System
WARNING
Radio waves from the key may affect medical devices such as pacemakers:
Before using the key near people who use medical devices, ask the medical device manufacturer or your physician if radio waves from the key will affect the device.
The advanced keyless function allows you to lock/unlock the door , or open the trunk lid while carrying the key.
System malfunctions or warnings are indicated by the following warning beeps.
- Request switch Inoperable Warning Beep. Refer to Request Switch Inoperable Warning Beep (With the advanced keyless function)
- Key Left-in-Trunk Warning Beep. Refer to Key Left-in-luggage Compartment Warning Beep (With the advanced keyless function).
- Key Left-in-vehicle Warning Beep. Refer to Key Left-in-vehicle Warning Beep (With the advanced keyless function).
NOTE
The advanced keyless entry system functions can be deactivated to prevent any possible adverse effect on a user wearing a pacemaker or other medical device. If the system is deactivated, you will be unable to start the engine by carrying the key. Consult an Authorized Mazda Dealer for details. If the advanced keyless entry system has been deactivated, you can start the engine by following the procedure indicated when the key battery goes dead.
Refer to Engine Start Function When Key Battery is Dead.
Operational Range
The system operates only when the driver is in the vehicle or within operational
range while the key is being carried.
NOTE
When the battery power is low, or in places where there are high-intensi ...
Other materials:
Mazda 6 Owners Manual: Clock spring inspection
1. Remove the clock spring.
2. Inspect for continuity between the clock spring terminals using an
ohmmeter.
If not as specified, replace the clock spring.
Note
When the vehicle-side connector of clock spring is disconnected,
the terminals 1A,1B, 1C and 1D are shorted to prevent ...
Mazda 6 Owners Manual: Theft-deterrent control module inspection
1. Remove the theft-deterrent control module without disconnecting the
connectors.
2. Measure the voltage at the theft-deterrent control module terminals as
indicated below.
3. Disconnect the theft-deterrent control module connector before inspecting
for continuity at terminals L, Q, S, T, a ...