Mazda 6 manuals

Mazda 6 Service Manual: Windshield washer nozzle removal/installation

Mazda 6 Service Manual / Body electrical system / Wiper and washer / Windshield washer nozzle removal/installation

1. Remove the bonnet insulator.

2. Remove the windshield washer hose from the windshield washer nozzle.

3. Compress the hooks of the windshield washer nozzle.

4. Pull the windshield washer nozzle out to remove it.


5. Install in the reverse order of removal.

Washer fluid-level sensor inspection
1. Disconnect the negative battery cable. 2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION) 3. Insoect for continuity between the washer fluid-level sensor terminals using an ohmme ...

Windshield washer nozzle cleaning
1. Clean the washer nozzle by inserting and moving a needle or an equivalent tool back and forth. If the nozzle becomes clogged again after cleaning, remove the hose from washer nozzle. Make ...

Other materials:

Mazda 6 Service Manual: Interior Lights
NOTE Do not leave the lights on for long periods while the engine is turned off. Otherwise the battery power could be depleted. Overhead Lights NOTE The rear map lights also turn on and off when the overhead light switch is operated. Front Map Lights When the overhead light switch is i ...

Mazda 6 Service Manual: Clock spring inspection
1. Remove the clock spring. 2. Inspect for continuity between the clock spring terminals using an ohmmeter. If not as specified, replace the clock spring. Note When the vehicle-side connector of clock spring is disconnected, the terminals 1A,1B, 1C and 1D are shorted to prevent ...

© 2016-2026 Copyright www.mazda6info.net