Mazda 6 Service Manual: Wheel hub, steering knuckle pre-inspection
Wheel Bearing Play Inspection
1. Position a dial indicator against the wheel hub.
2. Push and pull the wheel hub by hand in the axial direction and measure the wheel bearing play.
Maximum wheel bearing play 0.05 mm {0.002 in}
3. If the bearing play exceeds the specification, replace and tighten the locknut to the specified torque and retest.
- Replace the wheel bearing as necessary.
Front axle
...
Wheel hub bolt replacement
1. Remove the hub bolt using the SSTs.
Note
If the dust cover interferes with the wheel hub bolt and the wheel
hub bolt cannot be removed, tap the part shown in the figure with a chisel
l ...
Other materials:
Mazda 6 Service Manual: Rear wheel alignment
Specification (Unloaded)*1
Normal
Elevated*3
*1 : Engine coolant and engine oil are at specified level. Spare tire, jack
and tools are in designated position.
*2 : Difference between left and right must not exceed 1°30'.
*3 : Distance between wheel center and fender brim is 392 mm {15.4 ...
Mazda 6 Service Manual: Removal/Installation
To remove the head restraint, pull it up while pressing the stop-catch.
To install the head restraint, insert the legs into the holes while pressing
the stop-catch.
WARNING
Always drive with the head restraints installed when seats are being used
and make sure they are properly installed: Dri ...