Mazda 6 Service Manual: Variable valve timing actuator removal/installation
L3
Caution
- Variable valve timing actuator can not be disassembled because it is a precision unit.
Note
- Variable valve timing actuator camshaft sprocket is integrated with the variable valve timing actuator and cannot be disassembled.
1. Follow the timing chain removal/installation procedure from 1 to 13 and remove the timing chain. (See TIMING CHAIN REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Variable Valve Timing Actuator Removal Note
1. Set a wrench or equivalent tool at the hexagonal part of the camshaft to prevent rotation.
2. Loosen the variable valve timing actuator tightening bolts.
Variable Valve Timing Actuator Installation Note
1. Set a wrench or equivalent tool at the hexagonal part of the camshaft to prevent rotation.
2. Tighten variable valve timing actuator tightening bolts.
Tightening torque 69-75N·m {7.10-7.6 kgf·m, 50.9-55.3 ft·lbf}
Variable valve timing actuator inspection
L3
Caution
Variable valve timing actuator can not be disassembled it is a
precision unit.
1. Disconnect the negative battery cable.
2. Remove the plug hole plate.
3. Remove the high-tensi ...
Other materials:
Mazda 6 Service Manual: Door lock timer unit inspection
1. Measure the voltage at the door lock timer unit terminals (other than
terminal 1E and 2W) as indicated below.
If not as specified, inspect the parts listed under Action.
2. Disconnect the negative battery cable.
3. Disconnect the door lock timer unit connector and inspect for continuity ...
Mazda 6 Service Manual: Glass panel adjustment
1. Fully close the glass panel.
2. Measure the gap and height between the glass panel and body.
3. If not as specified, loosen the glass panel installation screws and
reposition the glass panel.
Clearance
a: -0.8-1.2 mm {-0.032-0.047 in}
b: 0 mm {0 in}
4. Tighten the installation scre ...