Mazda 6 manuals

Mazda 6 Service Manual: Trunk lid trim removal/installation

Mazda 6 Service Manual / Body / Trim / Trunk lid trim removal/installation

1. Pull the handle toward you, then remove the handle.


2. Remove the fasteners, then remove the trunk lid trim.

3. Install in the reverse order of removal.

Trunk side upper trim removal/installation
1. Disconnect the negative battery cable. (LH only) 2. Remove the tire house trim. 3. Remove the rear seat remote lever. 4. Remove the screw. 5. Pull the trunk side upper trim toward you, then d ...

Trunk end trim removal/installation
4SD 1. Remove the fasteners. 2. Pull the trunk end trim upward, then disengage clips A, pins B, and hooks. 3. Remove the trunk end trim. 4. Install in the reverse order of removal. 5HB 1. Pull ...

Other materials:

Mazda 6 Service Manual: Transaxle range (tr) switch inspection
Operating Inspection 1. Verify that the starter operates only when the ignition switch is at the START position with the selector lever in P or N position. If not as specified, adjust the TR switch. 2. Verify that the back-up lights illuminate when shifted to R position with the ignition ...

Mazda 6 Service Manual: Diagnostic trouble code number inspection
1. Remove the glove compartment. 2. Short the A/C check connector to the GND terminal using a jumper wire. 3. Shine a 60 W incandescent light from a height of approximately 100 mm {3.9 in} onto the solar radiation sensor. Note When incandescent light does not shine on the solar radiatio ...

© 2016-2026 Copyright www.mazda6info.net