1. Disconnect the negative battery cable.
2. Remove the plug hoie plate.

3. Disconnect the high-tension lead.

4. Remove the spark plugs using the plug-wrench.
5. Install the spark plugs using a plug-wrench.
Tightening torque: 10-24 N·m {1.1-2.4kgf·m, 8-17ft·lbf}
6. Install the plug hole plate.
Caution
(1) To position the plug hole plate, grasp the rubber 1 and 2, as shown in the figure, with your hands and press them in.
(2) Route the accelerator cable more towards the center of the plug hole plate underside to avoid the rib area as shown in the figure.
(3) Grasp rubber 3 with your hand and press it in.
(4) Grasp clips 4 and 5 with your hands and press them in.
7. Connect the negative battery cable.


Ignition coil inspection
Spark plug inspectionMazda 6 Service Manual: Driving Position Memory (Some models)
The desired driving position can be called up after programming the position.
The following driving positions can be programmed.
Driver’s seat position (seat slide, height adjustment, front edge of seat
bottom, seat recline)
Active driving display (display position, brightness level, dis ...
Mazda 6 Service Manual: Air filter inspection
1. Remove the air filter.
2. Inspect the air filter.
If the air filter is damaged, excessively dirty, or foul smelling,
replace the air filter.
Note
The air filter cannot be reused by cleaning it with water or
compressed air.
Replace the air filter at the following interval, depe ...