Mazda 6 Service Manual: Relay location

Cigarette lighter inspection

1. Turn the ignition switch to ACC position. 2. Verify that the cigarette lighter comes out within 10-20 seconds, after pressing the plug into the socket. If the cigarette lighter does not oper ...

Relay inspection

Relay Type Four-terminal Type A 1. Remove the relay. 2. Inspect for continuity between the relay terminals using an ohmmeter. If not as specified, replace the relay. Type B 1. Remove ...

Other materials:

Mazda 6 Service Manual: High Beam Control System (HBC) (Some models)
The High Beam Control System (HBC) determines the conditions in front of the vehicle using the Forward Sensing Camera (FSC) while driving in darkness to automatically switch the headlights between high and low beams. Refer to Warning/Indicator Lights. While driving the vehicle at a speed of ab ...

Mazda 6 Service Manual: Diagnostic trouble code number inspection
1. Remove the glove compartment. 2. Short the A/C check connector to the GND terminal using a jumper wire. 3. Shine a 60 W incandescent light from a height of approximately 100 mm {3.9 in} onto the solar radiation sensor. Note When incandescent light does not shine on the solar radiatio ...