Mazda 6 Service Manual: Rear spoiler removal/installation
1. Remove the trunk lid trim. (4SD)
2. Remove the liftgate lower trim. (5HB)
3. Remove the bolts.
4. Disconnect the high-mount brake light connector. (4SD)
5. Remove the rear spoiler.
6. Install in the reverse order of removal.
Rear finisher removal/installation
1. Remove the trunk lid trim (4SD).
2. Remove the liftgate lower trim (5HB).
3. Remove the nuts.
4. Pull the rear finisher toward you, then disengage clip A from the body.
5. Install in the reve ...
Roof carrier bracket removal/installation
1. Remove the headliner.
2. Remove the nuts.
3. Remove the roof carrier bracket.
4. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Shroud panel removal/installation
1. Remove the bonnet. (See BONNET REMOVAL/INSTALLATION.)
2. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)
3. Remove the front combination light. (See FRONT COMBINATION LIGHT
REMOVAL/INSTALLATION.)
4. Remove the front bumper reinforcement. (See BUMPER REINFORCEMENT
REMOVAL/ ...
Mazda 6 Service Manual: Outside Temperature Display
When the ignition is switched ON, the outside temperature is displayed.
NOTE
Under the following conditions, the outside temperature display may differ
from the actual outside temperature depending on the surroundings and vehicle conditions:
Significantly cold or hot temperatures.
Sudden ...