Mazda 6 Service Manual: Rear door structural view

Front door structural view

...

Front door removal/installation

1. Disconnect the negative battery cable. 2. To remove the front door hinge, remove the front fender panel. 3. To remove the checker, remove the door speaker. 4. Remove in the order indicated in th ...

Other materials:

Mazda 6 Service Manual: Pcv valve inspection
1. Disconnect the negative battery cable. 2. Remove the intake maniforld.(see INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.) 3. Remove the PCV valve. 4. Blow through the valve and verify that air flows as specified. If not as specified, replace the PCV valve. Specification ...

Mazda 6 Service Manual: No.7 abs warning light stays on more than 4 seconds with ignition switch on
Diagnostic procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure conne ...