Mazda 6 Owners Manual: Push-Starting
Do not push-start your Mazda.
WARNING
Never tow a vehicle to start it:
Towing a vehicle to start it is dangerous. The vehicle being towed could surge forward when its engine starts, causing the two vehicles to collide. The occupants could be injured.
CAUTION
Do not push-start a vehicle that has a manual transaxle. It can damage the emission control system.
NOTE
You cannot start a vehicle with an automatic transaxle by pushing it.
Starting a Flooded Engine
If the engine fails to start, it may be flooded (excessive fuel in the engine).
Follow this procedure:
1. If the engine does not start within five seconds on the first try, wait ten
seconds and tr ...
Overheating
If the high engine coolant temperature warning light turns on, the vehicle loses
power, or you hear a loud knocking or pinging noise, the engine is probably too
hot.
WARNING
Pull over to a safe ...
Other materials:
Mazda 6 Owners Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection
Note
Perform the following inspection only when directed.
1. Warm up the engine and run it at idle.
2. Disconnect the HO2S connector.
3. Connect the voltmeter test leads to the following HO2S terminals:
HO2S (front and rear)
- (+) leadterminal A
- (-) le ...
Mazda 6 Owners Manual: Bonnet switch inspection
Note
Bonnet switch has a built-in bonnet lock.
1. Open the bonnet.
2. Disconnect the negative battery cable.
3. Remove the radiator grille.
4. Disconnect the bonnet switch connector.
5. Check the continuity between the bonnet switch terminals A and B using an
ohmmeter.
If there is ...