
Keyless entry system preliminary inspectionMazda 6 Service Manual: Barometric pressure (baro) sensor inspection
Note
Perform the following inspection only when directed.
The following vacuum values are indicated by relative pressure
from the barometric pressure sensor.
1. Connect the SSTs (WDS or equivalent) to the DLC-2.
2. Turn the ignition switch to ON.
3. Select BARO on the SSTs (WDS or equi ...
Mazda 6 Service Manual: A-pillar trim removal
1. Turn the seaming welt over.
2. Disengage clips A using a fastener remover.
3. Pull the A-pillar trim, then disengage clip B (1).
4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar
trim (2).
5. Pull clip B out, then rotate 45°.
6. Remove clip B from the grommet b ...