Mazda 6 manuals

Mazda 6 Service Manual: No.26 starter does not work


No.25 engine stalls when driving at slow speeds or stopping
Diagnostic procedure ...

No.27 hold indicator light does not illuminate when hold switch is turned to on
Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm inspection
1. Disconnect the negative battery cable. 2. Connect the SST between the ABS (ABS/TCS) HU/CM and harness connector with the ignition switch off. 3. Attach the tester leads to the SST and inspect voltage referring the table below. Terminal Voltage Table (Reference) (Engine is idling, and co ...

Mazda 6 Service Manual: Engine control system operation inspection
Main Relay Operation Inspection Verify that the main relay clicks when the ignition switch is turned to ON position and off. If there is no operation sound, inspect the following. - Main relay (See RELAY INSPECTION.) - Harness and connector between ignition switch and main relay termi ...

© 2016-2026 Copyright www.mazda6info.net