Mazda 6 manuals

Mazda 6 Service Manual: Knock sensor removal/installation

1. Remove the intake manifold. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)

2. Remove the knock sensor attachment bolt to remove the knock sensor.


3. Install in the reverse order of removal.

Tightening torque 16.2-23.8 N·m
{1.66-2.42 kgf·m, 12.0-17.5 ft·lbf}

Knock sensor inspection
Note Perform the following test only when directed. Resistance Inspection 1. Turn the ignition switch to LOCK. 2. Disconnect the knock sensor connector. 3. Measure the resistance between the ...

Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test le ...

Other materials:

Mazda 6 Service Manual: Dashboard Illumination
(Without auto-light control) When the position lights are turned on with the ignition switched ON, the brightness of the dashboard illumination is dimmed. (With auto-light control) When the position lights are turned on with the ignition switched ON, the brightness of the dashboard illuminati ...

Mazda 6 Service Manual: No.1 abs warning light, brake system warning light, tcs off light do not illuminate with ignition switch on
Vehicle with ABS/TCS When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure conn ...

© 2016-2026 Copyright www.mazda6info.net