Push Button Start Positions
The system operates only when the key is within operational range.
Each time the push button start is pressed, the ignition switches in the order of off, ACC, and ON. Pressing the push button start again from ON switches the ignition off.
NOTE
Off
The power supply to electrical devices turns off and the push button start indicator light (amber) also turns off.
WARNING
Before leaving the driver's seat, always switch the ignition off, set the parking brake, and make sure the selector lever is in P (automatic transaxle) or in 1st gear or R
(manual transaxle):
Leaving the driver's seat without switching the ignition off, setting the parking brake, and shifting the selector lever to P (automatic transaxle) or to 1st gear or R (manual transaxle) is dangerous. Unexpected vehicle movement could occur which could result in an accident.
In addition, if your intention is to leave the vehicle for even a short period, it is important to switch the ignition off, as leaving it in another position will disable some of the vehicle's security systems and run the battery down.
ACC (Accessory)
Some electrical accessories will operate and the indicator light (amber) illuminates.
NOTE
The keyless entry system does not function while the push button start has been pressed to ACC, and the doors will not lock/unlock even if they have been locked manually.
ON
This is the normal running position after the engine is started. The indicator light (amber) turns off. (The indicator light (amber) illuminates when the ignition is switched ON and the engine is not running.)
Some indicator lights/warning lights should be inspected before the engine is started.
NOTE
When the push button start is pressed to ON, the sound of the fuel pump motor operating near the fuel tank can be heard. This does not indicate an abnormality.
Mazda 6 Owners Manual: Transaxle fluid temperature (tft) sensor removal/installation
Warning
When the transaxle and ATF are hot, they can badly burn. Turn off
the engine and wait until they are cool before replacing the ATF.
1. Remove the oil pan. (See CONTROL VALVE BODY REMOVAL.)
2. Disconnect the TFT sensor connector.
3. Remove the TFT sensor.
4. Install a TFT senso ...
Mazda 6 Owners Manual: Power outside mirror inspection
1. Disconnect the power outside mirror connector.
2. Apply battery positive voltage to the power outside mirror terminals and
inspect the operation of the power outside mirror.
If not as specified, replace the power outside mirror.
3. Inspect for continuity between the power outside mi ...