Mazda 6 manuals

Mazda 6 Service Manual: General procedures

Mazda 6 Service Manual / Steering system / General procedures

Wheels and Tires Removal/Installation

The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}.

Power Steering Components Removal/Installation

If any power steering fluid line has been disconnected anytime during the procedure, add ATF M-III

or equivalent (e.g. Dexron®II

), bleed the fluid lines, and inspect for leakage after the procedure has been completed.

Connectors Disconnection/Connection

Disconnect the negative battery cable before doing any work that requires handling of connectors. Reconnect the negative battery cable only after the work is completed.

Suspension Arm Removal/Installation

Tighten any part of the suspension that uses rubber bushings only after vehicle has been lowered and unloaded.

Note

 

Location index
STEERING LOCATION INDEX ...

Engine speed sensing power steering
...

Other materials:

Mazda 6 Service Manual: Illuminated Entry System
When the illuminated entry system operates, the overhead lights, the courtesy lights, and an ambient light* turn on in the following conditions: The driver's door is unlocked after the ignition is switched OFF. The ignition is switched OFF with all doors closed. NOTE (Overhead lights) ...

Mazda 6 Service Manual: Clock spring adjustment
Note The adjustment procedure is also specified on the caution label of the clock spring. 1. Set the front wheels straight ahead. Caution The clock spring will break if over-wound. Do not forcibly turn the clock spring. 2. Turn the clock spring clockwise until it stops. 3. Tu ...

© 2016-2026 Copyright www.mazda6info.net