Mazda 6 Service Manual: Fuse service caution

Mazda 6 Service Manual / Body electrical system / Power system / Fuse service caution

Caution

Determine and correct the cause of the burnt fuse before replacing it with the specified type. If the fuse is replaced before doing this, it may burn again.

Power system

...

Main fuse removal/installation

1. Disconnect the negative battery cable. 2. Remove the main fuse block cover. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Bolt Removal Note 1. ...

Other materials:

Mazda 6 Service Manual: Selector cable adjustment
1. Remove the center console. 2. Shift the selector lever to P position. 3. Unlock the lock piece of the selector cable (selector lever side) in the order shown in the figure. 4. Verify that the manual shaft is in P position. 5. Lock the lock piece of the selector cable (selector lever side) ...

Mazda 6 Service Manual: A-pillar trim removal
1. Turn the seaming welt over. 2. Disengage clips A using a fastener remover. 3. Pull the A-pillar trim, then disengage clip B (1). 4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar trim (2). 5. Pull clip B out, then rotate 45°. 6. Remove clip B from the grommet b ...