Mazda 6 Service Manual: Front buckle removal/installation
1. Perform the following procedure for vehicles with seat belt warning.
(1) Disconnect the negative battery cable.
(2) Remove the front seat.
(3) Disconnect the buckle switch connector.
2. Perform the following procedure for vehicles without seat belt warning.
(1) Remove the console.
3. Remove bolt.
4. Install in the reverse order of removal.
Rear center seat belt removal/installation
Caution
The ELR has a spring that will unwind if the retractor's cover is
removed. The spring cannot be rewound by hand. If this occurs, the ELR will
not work properly. Therefore, do not dis ...
Rear buckle removal/installation
1. Remove the rear seat cushion.
2. Remove the bolts.
3. Remove the rear buckles.
4. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Front combination light removal/installation
Caution
Incorrect servicing of the discharge headlights could result in
electrical shock. Before servicing the discharge headlights, always refer to
the Discharge headlight service warnings. (See DISCHARGE HEADLIGHT
SERVICE WARNINGS)
Note
When the ignition switch is turned to ON, ...
Mazda 6 Service Manual: A-pillar trim removal
1. Turn the seaming welt over.
2. Disengage clips A using a fastener remover.
3. Pull the A-pillar trim, then disengage clip B (1).
4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar
trim (2).
5. Pull clip B out, then rotate 45°.
6. Remove clip B from the grommet b ...