Mazda 6 Service Manual: Front and rear fog light switch inspection
Light switch LH side
1. Remove the light switch. (See LIGHT SWITCH REMOVAL/INSTALLATION.)
2. Inspect for continuity between the light switch terminals using an ohmmeter.
- If not as specified, replace the light switch.
Light switch RH side
1. Remove the light switch. (See LIGHT SWITCH REMOVAL/INSTALLATION.)
2. Inspect for continuity between the light switch terminals using an ohmmeter.
- If not as specified, replace the light switch.
Light switch inspection
Light switch LH side
1. Remove the light switch. (See LIGHT SWITCH REMOVAL/INSTALLATION)
2. Inspect for continuity between the light switch terminals using an
ohmmeter.
If not as specified, re ...
Headlight leveling switch removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Headlight Leveling Switch Removal Note
1. Insert your hand ...
Other materials:
Mazda 6 Service Manual: No.4 air intake mode does not change
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while performing the inspection to discover
whether poor contact points are the cause of any intermittent malfunctions.
If there is a problem, check to make sure connectors, terminal ...
Mazda 6 Service Manual: Picture Quality Adjustment
WARNING
Always adjust the picture quality of the rear view monitor while the vehicle
is stopped: Do not adjust the picture quality of the rear view monitor while
driving the vehicle. Adjusting the picture quality of the rear view monitor such
as brightness, contrast, color, and tint while dri ...