Mazda 6 Service Manual: Engine oil

Oil pressure inspection

Warning Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil. Hot en ...

Engine oil inspection

1. Position the vehicle on level ground. 2. Warm up the engine to normal operating temperature. 3. Stop the engine and wait for 5 min. 4. Remove the dipstick. 5. Verify that the oil level is betwe ...

Other materials:

Mazda 6 Service Manual: No.1 air bag system warning light does not illuminate
Diagnostic Procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connec ...

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...