
Diagnostic procedure



Procedures for determining the location of a malfunctionMazda 6 Service Manual: Dsc hu/cm removal/installation
Caution
When replacing the DSC HU/CM, configuration procedure must be done
before removing the DSC HU/CM. If configuration is not completed before
removing the DSC HU/CM, DTC B2477 will be detected.
Do not drop the DSC HU/CM. Replace it if it is subjected to an
impact.
1. Configura ...
Mazda 6 Service Manual: Spark plug removal/installation
1. Disconnect the negative battery cable.
2. Remove the plug hoie plate.
Lift off and remove the plug hole plate from the installation areas
(rubber and clips) as shown in the figure.
3. Disconnect the high-tension lead.
4. Remove the spark plugs using the plug-wrench.
5. Install th ...