Mazda 6 Service Manual: Dtc p0752

Dtc p0751

Dtc p0753

Other materials:

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...

Mazda 6 Service Manual: Coil removal/installation
Note Do not remove the coil unless you are replacing it. When only the coil is replaced, the immobilizer system reprogram procedure is not necessary. 1. Disconnect the negative battery cable. 2. Remove the column cover. 3. Remove in the order indicated in the table. 4. Install in ...