Mazda 6 Service Manual: Dtc b1601

Dtc b1602

Dtc b1213

Other materials:

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...

Mazda 6 Service Manual: No. 1 one or more on-board diagnostic functions inoperative
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunctions. If there is a problem, check to make sure connectors, terminals and wir ...