Mazda 6 Service Manual: Cowl grille removal/installation
1. Remove the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND BLADE REMOVAL/ INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Radiator grille removal/installation
1. Remove the screws.
2. Press clip A in the direction of the arrow, pll the radiator grille
outward and remove from the front bumper.
3. Install in the reverse order of removal. ...
Front flap removal/installation
1. Remove the screws and fastner.
2. Remove the front flap.
3. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Jacking positions ,vehicle lift (2 supports),safety stands (rigid rack)
positions
Jacking Positions
Warning
Improperly jacking a vehicle is dangerous. The vehicle can slip
off the jack and cause serious injury. Use only the correct front and rear
jacking points and block the wheels.
Use safety stands to support the vehicle after it has been lifted.
Fro ...
Mazda 6 Service Manual: Refrigerant pressure switch inspection
1. Install the SST (gas charging set).
2. Disconnect the refrigerant pressure switch connector.
3. Verify the high-pressure side reading of the SST (manifold gauge)
and continuity between the terminals of the refrigerant pressure switch.
If not as specified, replace the refrigerant pressure ...