Mazda 6 Owners Manual: Cooling (With air conditioner)

Mazda 6 Owners Manual / Interior Features / Climate Control System / Manual Type / Cooling (With air conditioner)

1. Set the mode selector dial to the position.

2. Set the temperature control dial to the cold position.

3. Set the fan control dial to the desired speed.

4. Turn on the air conditioner by pressing the A/C switch.

5. After cooling begins, adjust the fan control dial and temperature control dial as needed to maintain maximum comfort.

CAUTION

If the air conditioner is used while driving up long hills or in heavy traffic, monitor the engine coolant temperature warning light to see if it is illuminated or flashing.

The air conditioner may cause engine overheating. If the warning light is illuminated or flashing, turn the airconditioning off.

NOTE

When maximum cooling is desired, set the temperature control dial to the extreme cold position and set the air intake selector to the recirculated air position, then turn the fan control dial fully clockwise.
If warmer air is desired at floor level, set the mode selector dial at the position and adjust the
temperature control dial to maintain maximum comfort.
The air to the floor is warmer than air to the face (except when the temperature control dial is set at the extreme hot or cold position).

Heating

1. Set the mode selector dial to the position. 2. Set the air intake selector to the outside air position (indicator light turns off). 3. Set the temperature control dial to the hot position. 4 ...

Ventilation

1. Set the mode selector dial to the position. 2. Set the air intake selector to the outside air position (indicator light turns off). 3. Set the temperature control dial to the desired position ...

Other materials:

Mazda 6 Owners Manual: Combine sensor initialization procedure
1. Set the SST (WDS or equivalent) to the DLC-2 2. Access the active command mode and select the YAWRATE, then follow the indication on the monitor. 3. Select the LATACCEL and follow the indication on the monitor. STEERING ANGLE SENSOR REMOVAL/INSTALLATION (See COMBINATION SWITCH DISASSEMBLY ...

Mazda 6 Owners Manual: Magnetic clutch disassembly/assembly
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. 3. Adjust the magnetic clutch clearance. (See MAGNETIC CLUTCH ADJUSTMENT.) Bolt Removal/Installation Note 1. When removing or installing the bolt, hold the pressure plate in place as shown ...