Mazda 6 Service Manual: Automatic transaxle on-board diagnostic function
DTC Reading Procedure
(See ON-BOARD DIAGNOSTIC TEST.)
Foreword
When the customer reports a vehicle malfunction, check the malfunction
indicator lamp (MIL), HOLD indicator light flashing, and PCM memory for
diagnostic trouble code (DTC), then diagnose the ...
After repair procedure
Caution
After repairing a malfunction, perform this procedure to verify that the
malfunction has been corrected.
When this procedure is carried out, be sure to drive the vehicle at lawful
speed ...
Other materials:
Mazda 6 Service Manual: To Temporarily Cancel
To temporarily cancel the system, use one of these methods:
Slightly depress the brake pedal.
(Manual transaxle) Depress the clutch pedal.
Press the OFF/CANCEL switch.
If the RESUME/ switch is
pressed when the vehicle speed is 25 km/h (16 mph) or higher, the system reverts
to the prev ...
Mazda 6 Service Manual: No.7 abs warning light stays on more than 4 seconds with ignition switch on
Diagnostic procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there is a
problem, check to make sure conne ...