Mazda 6 Owners Manual: Indication/Indicator Lights
These lights turn on or flash to notify the user of the system operation status or a system malfunction.
*Some models.
*1 The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or when the engine is started. If the light does not turn on or remains turned on, have the vehicle inspected at an Authorized Mazda Dealer.
Warning Indication/Warning Lights
These lights turn on or flash to notify the user of the system operation status
or a system malfunction.
*1 The light turns on when the ignition is switched on for an operation check,
and t ...
Wrench Indicator Light (Some models)
When the ignition is switched ON, the wrench indicator light turns on and then
turns off after a few seconds.
The wrench indicator light turns on under the following conditions:
When the pres ...
Other materials:
Mazda 6 Owners Manual: Rear beltline molding removal
Note
When removing the rear beltline molding, the clip may be damaged.
If the clip is damaged, replace it with a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the B section of the front beltline molding in direction (2), along
the direction (1) shown in the figu ...
Mazda 6 Owners Manual: Crankshaft position (ckp) sensor inspection
Note
Perform the following inspection only when directed.
Resistance Inspection
1. Disconnect the CKP sensor connector.
2. Measure the resistance between CKP sensor terminals A and B using an
ohmmeter.
If not as specified, replace the CKP sensor.
If CKP sensor resistance is okay, bu ...